Free Nationwide delivery over $99
Genuine Aussie Stock
Complete Manufacturer’s Warranty
100% Secure Transactions
Dynavap SLIMSTASH: AFRICAN MAHOGANY
Vertigo Cyclone Triple Torch Lighter
DynaVap 2021 “M” Vaporizer
Dynavap The “M” Starter Pack 2021
Available on backorder
Dynavape DynaTec Apollo 2 Induction Heater - AUS Adaptor. The Apollo 2 wall-powered Induction Heater is designed and engineered by DynaTec, specifically for use with the DynaVap VapCap. Enjoy smooth, fast, and consistent vapor in 5-8 seconds with either stainless steel or titanium tips. To operate: lightly press the VapCap into the chamber until a red heating light appears and hold until you hear the heat-up click. A momentary tactile switch is built into the chamber to ensure the heater is only activated when a VapCap is inserted with light pressure.
An automatic shutoff feature limits heating to a maximum of 15 seconds at a time. This unit features a durable, full-colour printed cover with an authentic DynaVap magnet on the top.
Included with each Apollo heater is an instruction guide and a two-wire plug, with two round prongs, that fit into any 4.0 - 4.8 mm round contacts on 17.5 - 19 mm centre.
The Apollo 2 induction heater is for sure easier then a lighter to use when heating a vapcap but there is still a bit of a learning curve. So far in our own testing we have found especially on the first heat cycle that a couple of extra seconds of heating is required to get any sort of vapour on the the first cycle. Consequent heat cycles once there is some heat in your vapcap require less heating so stopping at the click is usually the way to go. But of course a bit of experimentation is always helpful just to find that sweet spot for your own taste.
Step 1 Plug the Apollo 2 Induction Heater into the wall and push the switch in found on the back of the unit.
Step 2 Load your Dynavap vaporizer as you normally would.
Step 3 Push your Dynavap vaporizer into the induction heater. There is a button inside the induction that gets pressed in when your vapcap is inserted. This is what engages the heater. A red light will signal the heater is in action.
Step 4 Once that awesome click is heard you are ready to inhale. And remember sometimes an extra couple of seconds is necessary to get what you are after.
Step 5 Repeat steps 3 and 4 until your herb is spent.
*Comes with Aussie Adaptor
Copyright © 2022 MyNextVape. All Rights Reserved.